Smooth Onewheel Fender for Plus and XR - SPLIT BASE

Ive split the base in half for those with smaller printer sizes. Just print the base file twice since it is symmetrical in design.

This is a smooth "slick" version of the original fender.

This is a convertible fender with a slick motorcycle tire style. The top is removable. There are recesses on each side where the top and base meet for a 5/16" diameter x .118" thick rare earth magnet.8 in total. Although it does hold well enough to not need them.

The base is printable without supports The top however will need them since it sits on the 4 corners of the dome shape. I set the support overhang angle to 5 degrees to generate support under the entire piece. It's recommended to use ABS or some other high temp resistant filament but anything will really work.